So the project I created was a "Frosty" shaker card.
This is how I created him.
1. Attach the blue piece of Cardstock to the white base piece, aligning it in the middle. Next, put foam tape around the outside of the blue Cardstock where the white border is.
2. Next, go ahead and expose the top of the tape. Attach "Frosty" ( Fun Stampers Journey ATS) to the left corner of the card.
3. Go ahead and place some wet adhesive over the areas in the tape that "Frosty" covered. When you are almost ready to put the acetate on, pour some of your favorite glitter and sequins on top of him.
4. Place the acetate on top, making sure that all of the sides are attached. Then place, the white border over the top with some more adhesive. Your done! Enjoy!
Post a Comment